AnyTone AT-588UV User Manual download pdf (Page 17)

In standby, press key or Microphone's

key until appear , this indicates current

channel in channel mode. Repeat above

PWR KEY

Dial

Frequency

decrease

Frequency

increase

Volume Knob

Min

Volume

Max

Volume

Basic Operations

Switching The Power On/Off

Adjusting The Volume

Switch between VFO and Channel mode

Adjusting Frequency/Channel THROUGH SELECTOR KNOB

Receiving

according to the option selected during

installation Press the switch or turn the

ignition key to ACC (speed up) or ON (startup)

position to power on radio . Press the key

for 1s or turn the ignition key to OFF position

to turn off.

When the channel you are operating is

called, the screen shows

and field

intensity, in this way, you can hear the calling

from transmitting party.

Under frequency (VFO) mode, you can

change the current frequency to the

desired one through selector knob; Turn

clockwise to increase frequency; turn

counterclockwise to decrease. Every

gear will increase or decrease one step.

Press

key, the decimal point of

Turn the VOL knob clockwise to increase

the audio level, counterclockwise to decrease.

During communication, volume can be adjusted more accurate.

5k, 6.25k, 8.33K,10k, 12.5k, 20k, 25k, 30k and 50k total

nine step size

available for this radio.

If the transceiver has set at higher squelch level, it may fail to hear the calling.

operation to switch between Frequency mode

(VFO) and

Channel mode.

frequency in screen will be auto-hidden. In this status,

turn selector

knob or Microphone [

/ ] key will increase or decrease

frequency

quickly by 1MHz step .

Under channel mode, you can change the current channel to the

desired one through selector knob, clockwise turn to the forward

channel, anticlockwise turn to the backward channel. In relative

working mode, Microphone's [

/ ] key has same

function for adjusting frequency and channel.

Transmitting

Press and hold key or press MIC's key to monitor for a while

WRFRQ¿UPWKHFKDQQHOGHVLUHGLV QRWEXV\

Release

or press Mic's

key to return standby status,Then press and hold [PTT] key to speak

into microphone.

When the channel you are operating is called,the screen shows BUSY

and field intensity,you can't hear the calling from transmitting party,it

means current channel receives a matching carrier but unmatching

signaling(Refer to CTCSS/DCS encode and decode or Optional Signaling

setup).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 42 43

Comments to this Manuals

No comments

AnyTone AT-588UV User Manual Page 17

Comments to this Manuals

Related products and manuals for Radios AnyTone AT-588UV