AnyTone AT-588UV User Manual download pdf (Page 37)

This feature will copy the programmed data and parameters in the master unit to slave units. It copies the parameters and memory program settings.

Use optional CP50 cloning cable, connect the cable between the data jacks on both master and slave.

Press and hold key, then press key to enter into cloning mode, LCD displays "

CLONE".

Press master unit's [PTT] key, LCD displays "SD XXX", "XXX" indicates data volume in transmitting. Slave unit displays "LD XXX", "XXX" indicates

received data volume. When the transmission is successfully finished, the master and slave unit both display "PASS". Turn off the power,

disconnect the cable and repeat step 2 to step 3 operations to clone the next slave unit.

Cable Clone

If the data is not successfully transmitted, turn off both units, make sure the cable connection is correct and repeat the entire operation from the beginning.

GND DATA TX/RX

Master/Slave stereo plug,3.5mm plug

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43

Comments to this Manuals

No comments

AnyTone AT-588UV User Manual Page 37

Comments to this Manuals

Related products and manuals for Radios AnyTone AT-588UV